Code Reference for Ecovacs Deebot Ozmo 950

Use this reference to understand the AUTO Mode Button lights and review practical checks for charging, cleaning, mopping, scheduling, and Wi-Fi setup.

AUTO Mode Button Status

[reference] Title: Solid white Text: The robot is cleaning or paused while cleaning. Title: Flashing white Text: The robot is charging, starting, or relocating. Title: Solid red Text: The battery is low. Title: Flashing red Text: The robot needs attention. [/reference]

Charging and Docking

• Make sure DEEBOT is switched on before charging.
• Check that the robot's Charging Contacts are aligned with the Docking Station Pins.
• Make sure the Power Cord is firmly connected and the Docking Station has power.
• If the battery is completely discharged, switch DEEBOT on and place it on the Docking Station by hand. Charge for 3 minutes, remove it, and repeat this cycle three times before charging normally.
• If DEEBOT has difficulty returning to the Docking Station, check the station placement and reposition it if needed.

[note] Returning to the Docking Station before cleaning is complete can be normal when the battery becomes low. Working time can also vary with the floor surface, room complexity, and selected Cleaning Mode. [/note]

When Cleaning Stops

Floor obstacles can interrupt a cleaning run.

• Check for electrical wires, curtains, carpet fringing, or other items that may be tangled around the robot.
• DEEBOT may try to free itself automatically. If it cannot, remove the obstruction manually and restart the cleaning run.
• If some areas are missed, remove small objects and tidy the cleaning area before the next run.

Scheduled Cleaning

• Confirm that Time Scheduling is active and the desired cleaning times are set in the ECOVACS App.
• If Continued Cleaning is enabled and DEEBOT has just completed the scheduled area, no additional action may be needed.
• Keep DEEBOT switched on and connected to the Docking Station so the battery is ready for scheduled cleaning.
• If the battery is low, allow the robot to recharge before the next scheduled run.
• If airflow is restricted by debris, switch DEEBOT off, clean the Dust Bin, and check the Suction Intake, Side Brushes, and Main Brush.

Mopping Water Flow

• If the water inlet filter on the bottom of the Reservoir is clogged, unscrew the water inlet and clean the filter.
• If the Reservoir is empty, add water before mopping.
• If the water outlets on the bottom of DEEBOT are clogged, check and clean the outlets.

Wi-Fi Setup Checks

• Check that the home Wi-Fi username and password are entered correctly.
• Keep DEEBOT within range of the home Wi-Fi signal during setup.
• If network setup began before the robot was ready, turn on the Power Switch and press the RESET Button for 3 seconds.
• DEEBOT is ready for network setup after it plays a musical tune and the Wi-Fi Indicator begins flashing slowly.
• If setup still cannot continue, check whether the smartphone software needs to be updated.