Use this network setup reset after changing your Wi-Fi name or password, or after replacing the router when the robot does not reconnect. Afterward, the DEEBOT can be connected to the current network through the Ecovacs Home App again.
[reference]
Title: Network Setup Control
Text: Use the RESET Button on the DEEBOT OZMO 950 to start network setup.
Title: Ready Signal
Text: After holding RESET for about 3 seconds, the robot should play a tune and the Wi-Fi indicator should flash slowly.
Title: Reconnection
Text: Once network setup is ready, use the Ecovacs Home App to provide the current Wi-Fi details and add the robot again if required.
[/reference]
[note]
If a replacement router uses the same Wi-Fi network name and password, the robot may reconnect without new setup. Use this process when the network details have changed or the DEEBOT remains disconnected.
[/note]
[warning]
For network setup, use the RESET Button. A 3-second hold on the AUTO Mode Button is used for a different robot function.
[/warning]
Before You Start
[checklist]
* DEEBOT is powered on
* Current Wi-Fi network name and password are available
* DEEBOT is within range of the home Wi-Fi signal
* Ecovacs Home App is ready for network setup
[/checklist]
Reset and Reconnect Wi-Fi
- Press and hold the RESET Button for about 3 seconds.
Make sure the robot is switched on, then hold the RESET Button long enough to start network setup. Avoid using the AUTO Mode Button for this Wi-Fi procedure.
- Wait for the confirmation sound.
The DEEBOT should play a short tune after the network setup command is accepted. This indicates that it is preparing for Wi-Fi configuration.
- Check the Wi-Fi indicator.
When the DEEBOT is ready for network setup, its Wi-Fi indicator should flash slowly. Wait for this state before continuing in the app.
- Set up the Wi-Fi connection again.
Open the Ecovacs Home App and follow the network setup flow. Enter the current Wi-Fi details and add the DEEBOT again if the app requires it. After connection is complete, app-based control and network communication can resume.
Basic Check
[troubleshoot]
Problem: No confirmation tune or the Wi-Fi indicator does not begin flashing slowly
Cause: The robot may not be powered on, or network setup may not have started
Fix: Confirm that DEEBOT is switched on, then press and hold the RESET Button for about 3 seconds again
Problem: DEEBOT remains disconnected after network setup
Cause: The Wi-Fi details may be incorrect or the robot may be outside a reliable Wi-Fi range
Fix: Check the current network name and password, keep DEEBOT within range of the router, and repeat the network setup flow
[/troubleshoot]
[tip]
After changing the router, Wi-Fi network name, or password, use the current network details when reconnecting the DEEBOT in the Ecovacs Home App.
[/tip]
