Sensor Cleaning for Ecovacs Deebot Ozmo 950

Keep the sensor areas clean so the robot can use its navigation, obstacle-detection, and floor-edge sensing functions normally. This routine focuses on the underside cliff sensors and regular care of other sensor areas, including the laser sensor.

[reference] Title: Cliff Sensors Text: The underside sensor group used to detect floor edges and drops. The cleaning sequence below covers the five cliff sensors shown on the robot. Title: Laser Sensor Text: Keep the laser sensor clean as part of regular sensor care. [/reference] [warning] Set the Power Switch to the 0 position before turning the robot over or cleaning its sensors. [/warning]

Before Cleaning

[checklist] * Power Switch is set to the 0 position * A soft cloth is ready for gentle sensor cleaning [/checklist]

Clean the Sensors

1. Power off the Ecovacs Deebot Ozmo 950 by moving the Power Switch to the 0 position.
2. Turn the robot upside down to access the five cliff sensors on the underside.
3. Gently wipe each cliff sensor surface with the soft cloth. Remove visible dust without applying unnecessary pressure to the sensor areas.
4. Return the robot to its normal upright position.
5. Move the Power Switch to the I position to power the robot back on.

Routine Sensor Care

Include the cliff sensors and laser sensor in regular cleaning. Sensor surfaces can collect dust during normal vacuuming, so check them periodically and clean them when needed.

[tip] Keeping sensor surfaces free of dust supports normal navigation, obstacle awareness, and floor-edge detection. [/tip]

After Cleaning

[checklist] * All five cliff sensor areas have been gently wiped * The robot has been returned to its upright position * The Power Switch has been returned to the I position [/checklist] [dosdonts] Do: Handle the sensor areas gently during cleaning Do: Include the laser sensor in regular sensor care Do: Return the robot upright before resuming normal use Dont: Leave visible dust covering the cliff sensor areas [/dosdonts] [faq] Q: Which sensors should I clean during this routine? A: Clean the five cliff sensors shown on the underside and keep other sensor areas, including the laser sensor, clean as part of routine maintenance. Q: When should the sensors be cleaned? A: Check the sensor surfaces regularly and clean them when dust or debris is visible. Regular sensor care helps maintain normal sensing and navigation behavior. Q: What should I do after cleaning the underside sensors? A: Return the Ecovacs Deebot Ozmo 950 to its normal upright position, then move the Power Switch to the I position. [/faq]